To remove the blade, you must turn the blade’s retaining bolt to the left, or counterclockwise. Put the mower on its side with the engine air cleaner facing up and block the blade with a piece of wood or plastic. If you are using a lawnmower with an automatic transmission, the transmission will need to be replaced.
Table of Contents
How do you know if your lawn mower blade is backwards?
If on the right side, move the blade in a counterclockwise direction, and if on the left side, move it in a clockwise direction.). The edge that leads should be the sharp edge of the blade. If it does, you have the correct lawn mower blade position.
You need to do it again if you don’t get it. If you are not sure which side to use, try it on both sides and see which one works best for you.
Do all mower blades turn counterclockwise?
Most lawn mower blades rotate in a clockwise direction (counter-clockwise when viewed from below), and as such have the cutting edge on the right side. If you are unsure of how your mower rotates, check the position of the discharge chute; if it is on the right side, the blade is rotating counter-clockwise.
If you have a lawnmower with a rotating blade, you will need to rotate the blades in the opposite direction to the direction they are facing. To do this, simply turn the handle to one side, and then turn it back the other way. The blades will then rotate back to their original position.
Are John Deere lawn mower blade bolts reverse thread?
Most of the nuts that held the blade in place were reverse threaded. The reverse thread helps to hold the blade on the drive shaft so that it doesn’t loosen the nut. Not all lawnmowers use a reverse threaded blade, and some do not have a threaded shaft at all.
What size is the nut on a lawn mower blade?
The tractor cutting blade retainer nuts should be turned in one direction or the other. The retainer nut on most of our riding mower blades are a 5/8″ thread diameter. A 15/16″ wrench or socketstool is required in order to turn the nut. If you are using a different size nut, you may need to use a larger wrench.
Do mower blades turn clockwise?
The bolt often goes counter-clockwise when the lawnmower blades turn clockwise. If you want to check the mower’s bolt, you have to turn it off, remove the spark plugs, and lay the lawnmower on its side. If you’re not sure which direction the motor is turning, look at the rotor. If it looks like it’s spinning counter to the direction you want it to go, then you’ve got a problem.
Do lawn mower blades face up or down?
If you want to know which side of your lawn mower blade is up, you have to figure out which side is the sharp cutting edge and which side is the blunt edge. The cutting edge should face the grass while the dull edge should be facing away from the lawn.
If you have a lawnmower with an automatic blade, you will need to turn the blade counterclockwise to cut grass. If you do not have one of these blades, turn it clockwise until you find a blade that works for you.
