efficient. You will need to mow less frequently if you want to keep your lawn healthy. Replacing them is an easy project that won’t take up much time, as long as you have the right tools.
Table of Contents
Which way do I turn the bolt to remove a lawn mower blade?
To remove the blade, you must turn the blade’s retaining bolt to the left, or counterclockwise. Put the mower on its side with the engine air cleaner facing up and block the blade with a piece of wood or plastic. If you are using a lawnmower with an automatic transmission, the transmission will need to be replaced.
Which side of the lawnmower blade faces up?
The wings on the lawn mower blades are designed to point toward the cutting deck. If your lawn mower blade has wings, they should point towards the lawn mower.
If you have a lawnmower that has no wings and you want to use it to mulch, you will need to remove the wings from the blade.
You can do this by removing the blades with a pair of pliers, or you can use a small screwdriver to pry them off.
What size socket do I need to remove a lawn mower blade?
If you want to remove the blade retaining bolt, you will need a 15/16 inch wrench or a socketstool. Depending on the make and model of the lawnmower you are removing, this is the average sockets size.
You will want to use a torque wrench with at least 1/2 to 3/4 of an inch of torque. You should also be careful not to over-torque the bolt, as this can cause damage to the motor and/or blade.
How do you know if mower blade is upside down?
If on the right side, move the blade in a counterclockwise direction, and if on the left side, move it in a clockwise direction.). The edge that leads should be the sharp edge of the blade. If it does, you have the correct lawn mower blade position.
You need to do it again if you don’t get it. If you are not sure which side to use, try it on both sides and see which one works best for you.
How often should lawn mower blades be replaced?
A good rule of thumb for most homeowners is to replace their mower blades annually. You can prolong the life of your mower blades by sharpening them on a regular basis. If you are sharpening your blades at home, be sure to wear protective gear and disconnected the blades when not in use.
Do lawn mower blades turn clockwise or counterclockwise?
The bolt sometimes goes counter-clockwise. If you want to check the mower’s bolt, you have to turn it off, remove the spark plugs, and lay the lawnmower on its side. If you’re not sure which direction the motor is turning, look at the rotor. If it looks like it’s spinning counter to the direction you want it to go, then you’ve got a problem.
How tight should mower blades be?
The blade should be tight enough so that it doesn’t move around on its own, but you should be able to move with your hand by applying some pressure. The manufacturer should give a proper tightening level for foot-pounds, which can be found in the size of a dime.
What size socket do I need to remove a lawn mower spark plug?
The size of lawnmower spark plugs is different than the size of an automobile. The sizes of the sockets needed to remove them are around 13/16 or 1/3 in diameter. In order to use a lawn mower with a spark plug socket, you must remove the plug from the socket.
This can be done by unscrewing the screw and pulling it out, or by using a small screwdriver to pry it off. If you do not have access to a screw driver, then you will need to cut a hole in the side of your lawn chair and insert a piece of wire through the hole.
The wire should be long enough to reach all the way to the end of the lawn plug, but not so long that it will be in contact with the ground. Once the wire is in place, it is very important that you don’t bend or twist it, as this will damage the electrical connection.
