Scotts recommends a setting of 5 1/2 when overseeding and a bare-lawn setting of 8 1/2. Scotts recommends a setting of 4 when seeding a new lawn with a handheld broadcast spreader, but suggests that the sower make two passes over the lawn.
Scotts also recommends that a lawn be seeded in the spring with a 1-inch-thick layer of fine-leaved grass seed. The seed should be placed in a plastic bag and allowed to air-dry for at least 24 hours before planting. This will allow the seed to germinate and grow into a dense, well-drained lawn that will last for years to come.
Table of Contents
What spreader setting should I use?
Set your spreader so that the opening(s) in the bottom are ¾ open when engaged. Take a bag of milorganite and put it into your spreader. Continue until the spreader is empty as you begin fertilization along an edge. When you are ready to fertilize again, you will need to remove the excess fertilizer and place it in a plastic bag.
Place the bag in your compost pile and cover it with a layer of mulch. This will help keep the fertilizer from leaching into the soil. You can also use a garden hose to spray the top of the pile with water and let it sit for a day or two. If you do this, be sure to let the water run off the hose before putting it back in.
What is the spreader setting for Scotts EZ seed?
Scotts ez seed patch and repair sun and shade uses 20 lbs to treat 1,000 sq. ft., so you need a high spreader setting. If you are going to use this product, you will need to make sure that you have the correct amount of product in your container.
If you use too much, it will be difficult to spread the product evenly throughout the container and you may end up with a lot of excess product on the bottom of the pot. Also, if you do not have enough product to cover the entire surface of your plant, the plant will not be able to absorb the nutrients properly and will suffer from nutrient deficiencies.
Can I use a spreader for grass seed?
The most efficient way to distribute lawn-care products is through broadcast spreaders. A good rule of thumb is that if your lawn looks like it needs a lot of help, you probably don’t need one. But if it looks sick, it’s probably time to get rid of it and start over.
What do the numbers on a lawn spreader mean?
The numbers on a spreader tell you how much fertilizer or product will be applied over a certain amount of land. The most effective way to apply the product will be determined by the numbers you use.
For example, if you want to use 1,000 pounds of fertilizer per acre, you’ll need to multiply the number of acres by 2.5 to get the total amount you need. If you’re using 2,500 pounds, multiply that number by 3.25 to find out how many acres you have to cover.
What do the spreader settings mean?
The spreader setting is the rate at which you apply product to your lawn. Green products have recommended rates of application and coverage based on bag size. The application rate is the amount of material applied per unit area of the lawn, and the coverage is a measure of how much product is applied to the surface.
Which is better drop or broadcast spreader?
Different parts of the lawn will receive an even coverage if a broadcast spreader is used. A drop spreader, as previously mentioned, is more precise because it doesn’t broadcast the granular product or seed and doesn’t change the amount spread over the entire lawn.
If you have a large lawn, you may want to consider a sprayer that can spread the product over a larger area, such as a lawn mower. If you don’t have access to one of these types of sprayers, consider using a sprinkler system.
Sprinkler systems can be very effective at controlling weeds, but they are more expensive than a broadcast system and require a lot of maintenance.